Candy LS CDF 622 X - 86 S - Manual (Page 42)

83
Opening the door
Put your hand into the recess and pull.
If the machine comes open while it is working,
an electrical safety device automatically
switches everything off.
IMPORTANT
For the machine to work properly,
the door should not be opened while
it is in operation.
Closing the door
Place the baskets in the machine.
Make sure that both the spray arms are
free to rotate and are not obstructed by
cutlery, crockery or pans. Close the door,
pressing on it to make sure it is firmly shut.
82
Connecting the outlet hose
■ The outlet hose should disharge into a
standpipe, making sure that there are no
kinks (fig. 4).
■ The standpipe must be at least 40 cm
above floor level and it must have an
internal diameter of at least 4 cm.
■ It is advisable to fit an anti-odour air trap
(fig. 4X).
■ If necessary the outlet hose can be
extended up to 2,5 m, provided that it is
kept at a maximum height of 85 cm
above floor level. The extension pipe is
available from the After Sales Service
Centre.
■ The hose can be hooked over the side of
the sink, but it must not be immersed in
water, in order to prevent water from
being syphoned back to the machine
when this is in operation (fig. 4Y).
■ When installing the appliance under a
worktop the hose pipe clamp must be
attached to the wall in the highest possible
position under the worktop (fig. 4Z).
■ Check that there are no kinks in the inlet
and outlet hoses.
4
ISTALLATION
IN FITTED KITCHENS
■ Adjust the height of the dishwasher
according to the available space “A” of
fig. 2 (maximum 885 mm).
■ Ensure that the appliance is quite level
by adjustment of the rear feet (fig. 3).
■ If the underside of the worktop is of
water absorbent material (e;g. unfaced
chipboard) affix the self adhesive protec-
tive tape to it (fig. 1).
■ Insert the dishwasher under the worktop
and connect to the elec-tricity and water
supplies as shown in the instruction
book (fig. 2).
■ If necessary, final height adjustment ca
be achieved via the front feet and locked
by the fitted locking nuts.
■ Tighten the dishwasher to the worktop
by means of the 30 mm long screws “A”
shown in fig. 4.
The plinth is adjustable to allow perfect
cover of the bottom gat.
1
2
3
4