Candy GO F108__1-16S User Manual

Page 37

CHAPTER 13

FAULT

NOTE:

THE MACHINE IS FITTED WITH A SPECIAL ELECTRONIC DEVICE, WHICH PREVENTS THE SPIN CYCLE

SHOULD THE LOAD BE UNBALANCED.

THIS REDUCES THE NOISE AND VIBRATION IN THE MACHINE AND SO PROLONGS THE LIFE OF YOUR

MACHINE.

If the fault should persist, contact a Candy Technical Assistance Centre. For prompt servicing, give the model of
the washing machine, to be found on the label placed on the cabinet inside of the porthole or on the
guarantee certificate.
Important
1 The use of environment friendly detersives without phosphates may produce the following effects:

- The discharge rinse water may result cloudier due to the presence of zeolites in suspension. This does not

compromise the efficiency of the rinses.

- The presence of white powder (zeolites) on the washing at the end of the washing cycle. This does not

remain incorporated in the fabric and does not alter the colour.

- The presence of foam in the last rinse water which is not necessarily a sign of inadequate rinsing.
- The non-ionic surface-active agents present in the composition of washing machine detersives are often

difficult to remove from the washing itself and, even in small quantities, may produce visible signs of the
formation of foam.

- Carrying out further rinses, in cases such as this, is not useful.

2 If your washing machine fails to function, carry out the above-mentioned checks before calling the Candy

Technical Assistance Service.

1. Does not function

on any
programme

2. Does not load

water

3. Does not discharge

water

4. Water on floor

around washing
machine

5. Does not spin

6. Strong vibrations

during spin

Mains plug not plugged in

Mains switch not on

No power

Electric circuit fuses failure

Load door open

See cause 1

Inlet tap turned off

Timer not set correctly

Discharge tube bent

Odd material blocking filter

Leak from the washer between the tap
and inlet tube

The washing machine has not
discharged water

“No spin” setting (some models only)

Washing machine not perfectly level

Transport bracket not removed

Washing load not evenly distributed

Insert plug

Turn on mains switch

Check

Close load door

Check

Turn on water inlet tap

Set timer on correct position

Straighten discharge tube

Check filter

Replace washer and tighten the tube
on the tap

Wait a few minutes until the machine
discharges water

Turn the programme dial onto spin
setting

Adjust special feet

Remove transport bracket

Distribute the washing evenly

CAUSE

REMEDY