FIAT Punto Evo - Manual (Page 60)

SET TEMPERATURE ALIGNMENT
(MONO function)
Press the MONO button to align the temperature be-
tween the driver side and passenger side.
Then turn the AUTO or MONO knob to in-
crease/decrease the temperature between the two areas
by the same amount.
Press MONO again to deactivate the function.
CLIMATE CONTROL COMPRESSOR
ACTIVATION/DEACTIVATION
Press button ò to switch on the climate control system
compressor.
Compressor on
❒ the LED on button ò is lit up;
❒ symbol ò is shown on the display.
Compressor off
❒ the LED on button ò is lit up;
❒ symbol ò is shown on the display.
❒ internal air recirculation is prevented.
With the climate control compressor switched off, air can-
not be introduced into the passenger compartment at a
lower temperature than the outside; in this case the
ò
symbol on the display will flash.
The deactivation of the climate control compressor is
memorized even after the engine has stopped. To turn the
climate control compressor back on, press button
ò once
again or press AUTO: if you press AUTO, the other man-
ual settings will be cancelled.
SETTING THE AIR DISTRIBUTION
Press one or more of buttons
Q/E/Z to manually select
one of the 7 possible air distribution settings for the pas-
senger compartment:
Q
Air flow to the windscreen and front side window
vents to demist/defrost them.
Z
Air flow to the front and rear footwell vents. This
air distribution warms up the passenger compart-
ment quickly.
Q
ZE
Air flow distribution between front and rear vents,
centre/side dashboard vents, rear vent and wind-
screen and front side window demisting/defrosting
vents.
E
Air flow distribution to centre/side dashboard vents
(passenger’s body).
Q
Air flow distribution between the footwell
Z
vents and the windscreen and front side window
demisting/defrosting vents. This distribution setting
allows warms up the passenger compartment and
prevents the windows from misting up.
59
KNOWING
YOUR
VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
SERVICING
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
037-081 PUNTO FL EN 5ed 19-02-2010 11:46 Pagina 59