FIAT 600 User Manual

Page 12

The rear seat belts shall

be worn as shown in fig-
ure 6. Figure 6a shows

wrong seat belt fastening, not to
be followed.

GETTING TO KNOW YOUR CAR

fig. 7

P4Q00018

Remember that in the

case of violent collision,
back seat passengers not

wearing seat belts also represent
a serious danger to the front pas-
sengers.

ADJUSTING THE SEAT BELT
HEIGHT

There are two anchoring positions

A and B-fig. 7 for front seat belts on
the door post.

Before driving off for the first time,

adjust the position of the seat belt an-
choring point according to your height
and favourite driving position. If re-
quired, have the anchoring point of
the seat belt adjusted.

IMPORTANT Have this operation

performed at a Fiat Dealership only
as it involves passenger safety.

USING THE CENTRAL REAR
SEAT BELT
(For versions/markets)

To fasten the seat belt: push the

fastener tongue A-fig. 7a into slot B
of the buckle, until you hear it click.

To unfasten the seat belt: press

button C.

To adjust the belt: slide the web-

bing through D, pulling length E to
tighten and length F to loosen.

IMPORTANT The belt is adjusted

properly when it fits closely across the
hips.

fig. 7a

P4Q00037

In order to ensure that the correct

tabs are fitted into the corresponding
buckle, the tabs of the side belt and the
buckle of the centre seat (only ab-
dominal) are incompatible.