beautypg.com

Connecting cables – Eizo FlexScan SX2761W User Manual

Page 5

background image

3

English

Troubleshooting

Setting/Adjustment

Prior to use

Installation

Connecting Cables

Attention

• When replacing the current monitor with a SX2461W/SX2761W monitor, be sure to change the PC

settings for resolution and vertical frequency to those which are available for the SX2461W/SX2761W

monitor referring to the resolution table (back of cover page) before connecting the PC.

NOTE

• When connecting two PCs to the monitor, refer to the User’s Manual on the EIZO LCD Utility Disk (CD-ROM).

1

Check that the monitor and the PC are powered off.

2

Connect the monitor to the PC with a signal cable that matches the connectors.

After connecting the cable connectors, tighten the screws of the connectors to secure the coupling.

Connectors on

the PC

DVI connector

USB Downstream

Connectors on

the monitor

DVI-I connector

USB Upstream

EIZO USB cable MD-C93 (supplied)*

Signal cable FD-C39 (supplied)

Digital connection

Analog connection

Connectors on

the PC

USB Downstream

D-Sub mini 15-pin

connector

Connectors on

the monitor

DVI-I connector

USB Upstream

EIZO USB cable MD-C93 (supplied)*

Signal cable FD-C16 (supplied)

* Required when using the UniColor Pro software and the ScreenManager Pro for LCD software. (Refer to the

User’s Manual on the UniColor Pro (CD-ROM) or the EIZO LCD Utility Disk (CD-ROM).)

3

Plug the power cord into a power outlet and the Power connector on the monitor.