Connecting cables, Adjusting the screen angle – Eizo FlexScan S1501-B User Manual
Page 5
3
English
Troubleshooting
Setting/Adjustment
Prior to use
Installation
Connecting Cables
Attention
• When replacing the current monitor with a S1501-B monitor, be sure to change the PC settings for
resolution and vertical frequency to those which are available for the S1501-B monitor referring to the
resolution table (back of cover page) before connecting the PC.
NOTE
• When connecting two PCs to the monitor, refer to the User’s Manual on the CD-ROM.
1
Check that the monitor and the PC are powered off.
2
Connect the monitor to the PC with a signal cable that matches the connectors.
After connecting the cable connectors, tighten the screws of the connectors to secure the coupling.
Connectors on
the PC
DVI-D connector
D-sub mini 15-pin
connector
Connectors on
the monitor
DVI-D connector
D-sub mini 15-pin
connector
Stereo mini jack cable (supplied)
Signal cable MD-C87 (supplied)
Digital connection
Analog connection
CD player, etc
Signal cable FD-C39 (supplied)
Audio output
connector
Audio input
connector
or
3
Plug the power cord into a power outlet and the Power connector on the monitor.
Adjusting the Screen Angle
Tilt and swivel the screen to the best condition for working.