beautypg.com

No-picture problem, English, Check the power indicator – Eizo FlexScan S2100 User Manual

Page 8: Check the error message on the screen

background image

6

English

Prior to use

Installation

Setting/Adjustment

Troubleshooting

No-Picture Problem

If no picture is displayed on the monitor even after the following remedial action is taken, contact your local dealer.

1. Check the Power indicator.

Symptom

Status

Possible cause and remedy

No picture

Power indicator does not light

up.

Check whether the power cord is correctly

connected. If the problem persists, turn off the

monitor for a few minutes, and then turn it on

again.

Turn on the PC.

Power indicator lights blue.

Check the brightness setting.

Power indicator lights yellow.

Switch the input signal with .

2. Check the error message on the screen.

These messages appear when the input signal is incorrect even if the monitor is functioning.

Symptom

Status

Possible cause and remedy

The input signal is not received

correctly.

(This is displayed for about 40

seconds.)

Check whether the PC is turned on.

Check whether the signal cable is properly

connected to the PC.
Switch the input signal with .

The signal frequency is outside

the specification. Incorrect

signal frequency is shown in

red.

Change the mode to an appropriate mode using

the graphics board’s utility software. Refer to the

manual of the graphics board for details.