TIMBERK THU UL 06 series - Manual (Page 3)

3. TECHNICAL CHARACTERISTICS
ENGLISH
3 www.timberk.com electric humidifier
To prevent injuries and damage to property, do not try to repair the
humidifier on your own.
Take out the plug from an outlet in the following cases: prior to draining
or filling the tank with water; prior to cleaning and maintenance; prior to
mantling/dismantling of humidifier s elements; prior to transportation
of the humidifier to another place.
Install the humidifier on to a smooth dry surface. The outgoing steam
may damage surfaces it contacts. Do not install the humidifier on the
floor, as well as in the vicinity of heating appliances, furniture and other
objects.
The manufacturer and the seller do not bear any responsibility for
damages, inflicted due to improper position of the humidifier.
The humidifier should be installed on some kind of an elevation, for
example, on table, stand, etc.
It is not allowed to fill water into the humidifier through the atomizer.
Do not submerge the humidifier into water or other liquids.
Do not install the humidifier in places where it can be touched, tipped over, etc.
If the humidifier is not used, unplug it from electric mains.
Do not lay the power cord under a carpet or other objects. Position the
humidifier so that the power cord cannot be stumbled upon.
Do not use the humidifier in damp rooms.
Do not allow foreign object to get into the humidifier.
Do not block the air intake and humidifier s atomizer.
Do not sit, stand and put heavy objects on the humidifier.
To prevent damage of the humidifier, do not add essential oils,
preservatives, flavors and other foreign substances to humidification
water. The manufacturer and the seller do not bear any responsibility for
damages of the humidifier, inflicted due to failure to follow this
requirement.
Do not pull the power cord and do not touch it by wet hands when you
unplug the humidifier from electric mains.
Capacity of humidity, ml/h
Nominal power supply, V/Hz
Water tank, L
Nominal power consumption, W
Nominal rated current, A
Water protection
Electrical protection class
Device dimension, mm
Net weight, kg
300
220/50
3,5
30
0,136
IPX0
II cIass
269x165x269
1,9
The manufacturer reserves the right to change the set-list of the device (including liquid and powder
components) for different supplies without prior notice. The changes either in no way influence the basic
technical parameters of the device or may improve them, and also not violate the legislation or quality
standards of the countries of manufacture, transit and selling.
The changes in the set-list may result in changing of the weight and dimensions of the device, but not
more than by +\- 5-20% (depending on the product category)
Tabel 1