beautypg.com

SoundMax SM-2405 User Manual

Page 5

background image

5

Playback modes

Press REPEAT/PROG button repeatedly to switch between different playback modes.

During playing the mode will change as below: Repeat current track => Repeat all tracks => Normal

playback.

Program mode

Up to 20 tracks can be programmed for disc playback in any order.

Before use, be sure to stop the disc by pressing STOP button.

Press REPEAT/PROG. The set is now in memory programming mode, at the first memory position.

Select a desired track by pressing NEXT and BACK buttons.

Press REPEAT/PROG. The set will advance to next memory position.

Repeat the 2 last steps described above to enter additional memories into the program if necessary.

After a maximum of 20 tracks (or less) have been selected as described above, press PLAY button to

start playing the programmed tracks.

The program memory will be cleared when you press STOP button or turn off the CD-player or power

supply.

Note: Good quality sound is guaranteed only when playing licensed discs.

Maintenance and care

Check your batteries regularly; old or discharged batteries should be replaced. If the unit is not going

to be used for some time or is being run exclusively on the alternative power, remove the batteries to

avoid leakage and damage.

Electronic products of this kind should never be subjected to moisture or extreme temperatures.

If necessary, clean the unit with a piece of cloth dampened with water only (be sure the AC power cord

is disconnected from the power supply).

CD protection

When pick up the CD disc, always hold the edge of the disc, never touch the surface of the disc, it would

scratch the disc surface and may occur sound distortion or raise reading problem.