Binatone SI-2600 - Manual (Page 7)

7
ENGLISH
put the steam control knob (9) into the “0” position
prior to ironing at low temperatures.
Turbo steam
To ease ironing of dense cotton, linen and upholstery articles
use the steam burst button (8): engagement of the button (8)
during the ironing process generates an extra burst of steam from
the sole plate to help remove stubborn creases.
Burst of steam in a vertical position
This function helps to freshen the appearance of curtains, jack-
ets, coats, etc. To use this function, take the following steps:
Follow instructions in paragraph 1-4 of the section “Operation
instructions”. While selecting the temperature setting, put the
temperature control knob (10) into the “Max” position.
While holding the iron in a vertical position, aim its sole plate
towards the articles to be ironed and push the steam burst
button (8) to produce a directional strong burst of steam from
the sole plate. Push the button several times with 5-7 seconds
intervals until the article is fully refreshed. If during the process
your water tank (5) runs out of water, disconnect the appliance
from the mains outlet, wait till it cools down, refill the tank and
plug the appliance back into the power supply and continue the
process.
Spray
Using the water spray (7) will help when ironing details of the
article (cuffs, trimmings, plackets, etc) or clothes, which demand
“·” (low temperature) ironing, when steam ironing is not possible.
Push the button several times to moisten the material.
5. When you have finished cleaning or ironing, do not forget to
switch the iron off by putting the steam control knob (9) into
the “0” position, the temperature control knob (10) — into
the “Min” position and unplugging the appliance from the
mains supply outlet.
CARE AND MAINTENANCE
Cleaning of the sole plate
The scale on the sole plate can be removed
with a rough cotton cloth dampened with a
vinegar solution.
Do not use any abrasive substances and
materials to clean the sole plate.
Cleaning of internal parts of the appliance
SI-2610 iron is equipped with an anti-scale function which
protects it from an accumulation of scale: it does this with a built-in
permanent filter. Therefore the water hardness is reduced and
the useful service life of the iron is extended.
Warning: in areas with very hard water it is recommended
that you regularly remove scale from the appliance to