Hama BC-500D - Manual (Page 28)

Error Possible cause Solution
Flickering image
Distance between
baby unit and baby is
too small
Increase the distance between
the baby unit and baby.
Steel structures and
concrete walls may
have a negative effect
on transmission
Change the location of the baby
unit and parent unit.
Interference from
other devices
Switch to another channel.
Identify and remove the sources
of interference.
Audio feedback
Distance between the
baby unit and parent
unit is too small
Increase the distance to at least
1 metre.
Volume is too high Decrease the volume.
No connection
between the
parent unit and
baby unit
Different channels
have been set Ensure that the same channel is
set on both units.
Baby unit is not
switched on
Switch on the baby unit.
Distance between the
baby unit and parent
unit is too large
Reduce the distance between
the baby unit and parent unit.
Batteries in the baby
unit are too weak
Replace the batteries in the
baby unit or connect the power
supply adapter.
NOTE
► Contact our customer service department if the problem remains
after taking the steps detailed above.
Causes of errors and error rectifi cation
The following table can be used to localise and rectify minor errors
with the device:
Error Possible cause Solution
Display is empty
Device is switched
off
Switch on the device.
Power supply
adapter not
connected correctly Ensure that the power supply
adapter is plugged in and
connected to the device.
Batteries are empty
Replace the batteries or
recharge the rechargeable
batteries.
No mains power Check your fuse box..
Device is faulty
Inform our customer service
department.
No noises or
images recorded
by the baby unit
are shown on the
parent unit
Incorrect display
brightness Adjust the display brightness
according to the surroundings.
Device is not in
Normal mode Switch the device to Normal
mode.
Video Timeout is
activated
Switch on the video output..
Volume is too low Increase the volume.
Interference from
other devices
Switch to another channel.
Identify and remove the sources
of interference.
Displayed images
are too dark Image brightness is
set too low
Increase the display brightness.
54 Baby-Control BC-500D
GB
55 Baby-Control BC-500D
GB
00092662man_de_en_es_fr_pl_ru.indd Abs3:54-Abs3:55 00092662man_de_en_es_fr_pl_ru.indd Abs3:54-Abs3:55 08.02.10 07:57 08.02.10 07:57