Fein DSeu 638 - Manual (Page 13)

13 en
en Original Instructions for Drill/Impact Drill.
Symbols, abbreviations and terms used.
Symbol, character Explanation
General prohibition sign. This action is prohibited.
Do not touch the rotating parts of the power tool.
Make sure to read the enclosed documents such as the Instruction Manual and the General
Safety Instructions.
Before commencing this working step, pull the mains plug out of the socket. Otherwise there
will be danger of injury if the power tool should start unintentionally.
Use eye protection during operation.
Use ear protection during operation.
Additional information.
Confirms the conformity of the power tool with the directives of the European Community.
This sign indicates a possible dangerous situation that could cause severe or fatal injury.
Worn out power tools and other electrotechnical and electrical products should be sorted
separately for environment-friendly recycling.
Product with double or reinforced insulation
1st gear/2nd gear
Low speed
High speed
Character Unit of measure,
international Unit of measure,
national Explanation
P
1
W W Power input
P
2
W W Output
U V V Rated voltage
f Hz Hz Frequency
n
0
/min rpm No-load speed
n
1
/min rpm Speed, full load
n
S
/min /min Impact rate
M... mm mm Size of metric thread
Ø mm mm Diameter of a round part
mm mm Drilling diameter, steel
mm mm Drilling diameter, aluminium
mm mm Drilling diameter, wood
mm mm Drilling diameter, stone
mm mm Tap
mm mm d1 = Clamping range of drill chuck
d2 = Shank size of drilling shaft
d3 = Collar diameter
kg kg Weight according to EPTA-Procedure 01/2003
L
wA
dB dB Sound power level
WARNING
Fe
Al
OBJ_BUCH-0000000016-001.book Page 13 Wednesday, October 13, 2010 1:40 PM