9environment, 10 eu declaration of conformity – Festool TPE-RS 100 Q User Manual
Page 11
TPE-RS 100 Q
11
GB
Firstly, join the two halves of the handle together.
Put the thinner end [4-7] into the barrel with the
two-pointed prongs [4-1].
Push the nuts [4-3] through both large holes (Ø
9 mm/[4-2]) and screw them in with the SW 5
Allen key [4-6].
Now from the top of the barrel push on the ad-
ditional grips [4-5] and then the pad [4-4].
Now place the fastening segment [3-1] onto the
carpet remover gear housing [3-8].
Hang the wire clamps [3-7] to the right and left
on the hooks [3-9] next to the “ABWEISER” and
close the catches from behind [3-6].
Now connect the handle with the fastening seg-
ment.
Put the ridges [3-2] into the grooves [3-3] on
the fastening segment.
Screw both sides together with the washer and
the Allen key screw SW 6 [3-5].
Application
Depending on the size of the operator the additional
grips and the shoulder pad are placed on the han-
dle in such a way as to ensure optimum removal at
the best angle [1].
9
Environment
Do not throw the power tool in your household
waste! Dispose of machines, accessories and pack-
aging at an environmentally responsible recycling
centre. Observe the valid national regulations.
EU only: European Directive 2002/96/EC stipulates
that used electric power tools must be collected
separately and disposed of at an environmentally
responsible recycling centre.
Information on REACh:www.festool.com/reach
10
EU Declaration of Conformity
We declare under sole responsibility that this prod-
uct complies with the following directives and stan-
dards:
2006/42/EC, 2004/108/EC, 2011/65/EU, EN 60 745-
1, EN 55014-1, EN 55014-2, EN 61000-3-2, EN
61000-3-3.
Festool Group GmbH & Co. KG
Wertstr. 20, D-73240 Wendlingen, Germany
Dr. Martin Zimmer
Head of Research, Development and Technical
Documentation
12.02.2013
Carpet remover
Serial no.
TPE-RS 100 Q
490039
Year of CE mark: 1999