Pioneer AVX-7300 - Manual (Page 12)

7
Operation of the Display
• Turn your vehicle’s engine ON.
The display will be automatically deployed by the automatic close/open mode.
If the display is not automatically deployed, press the OPEN/CLOSE button.
Note:
• The automatic close/open mode will operate the display as follows.
* When the ignition switch is turned OFF while the display is deployed, the display will be
closed after approximately 6 seconds.
When the ignition switch is turned ON again (or turned to ACC), the display will be
deployed automatically.
* When using an AUDIO VISUAL MASTER UNIT, turning the power of either of these on
will deploy the display automatically.
* Installing the front panel will automatically deploy the display. (Refer to page 5.)
• The automatic close/open mode can be switched ON/OFF. (Refer to page 14.)
• When the ignition switch is turned OFF after the display has been closed, turning the ignition
switch ON again (or turning it to ACC) will not deploy the display. In this case, press the
OPEN/CLOSE button to deploy the display.
Operation of the Display
Deploying the Display