Yamaha RX-V692 RX-V592 - Manual (Page 26)

24
1
Select the source to be recorded.
2
Play the source and then turn the VOLUME control up
to confirm the input source. (For detailed information
on the tuning operations, refer to the page 26.)
3
Begin recording on the tape deck (or MD recorder etc.)
or VCR connected to this unit.
4
If the tape deck (or MD recorder etc.) is used for
recording, you can monitor the sounds being recorded
by pressing TAPE (MD) MON so that “TAPE
MONITOR” lights up on the display.
Notes
● The settings of DSP and the VOLUME, BASS, TREBLE,
BALANCE controls and the BASS EXTENSION switch
have no effect on the material being recorded.
● In step 1, do not make an input source selection so that
“6ch” appears on the display. Signals input to this unit’s
6CH DISCRETE INPUT DVD/LD TV/DBS terminals cannot
be recorded by a tape deck, MD recorder or VCR.
l6
20
28
40
60
l2
8
4
2
0
–dB
VOLUME
TO RECORD A SOURCE TO TAPE (OR MD)
2
l6 20
28
40
60
l2
8
4
2
0 –dB
1 4
VCR DVD/LD TV/DBS
VIDEO AUX TAPE (MD) MON 2CH/6CH
TUNER CD PHONO
To listen to a decoded source using Dolby
Digital (AC-3) by reproducing the signals input
to the 6CH DISCRETE INPUT DVD/LD TV/DBS
terminals of this unit.
In step 3, select TV/DBS or DVD/LD, and then press the
2CH/6CH button so that “6ch” appears on the display.
Discrete signals from the unit connected to the 6CH
DISCRETE INPUT DVD/LD TV/DBS terminals of this unit are
selected as the input signals.
To cancel it, press the 2CH/6CH button again or select another
input source.
Note for reproducing discrete signals with Dolby Digital
(AC-3) decoded:
1. Your speaker system must include a center speaker.
2. Your speaker system must include a subwoofer.
* Connect a subwoofer which has a built-in amplifier to the
SUBWOOFER OUTPUT terminal of this unit.
* You can do without using a subwoofer. If you do so, you
should make a setting for distributing signals at the LFE
channel to the right and left MAIN output terminals on the
Dolby Digital (AC-3) Decoder unit.
For details, refer to the owner’s manual for the Dolby
Digital (AC-3) Decoder unit.
Notes
● When you switch to the “6CH” mode, the built-in Digital
Sound Field processor will not work and adjustment of delay
time cannot be made.
● Switching this unit to the “6CH” mode will input no signal to
this unit if there is no connection to the 6CH DISCRETE
INPUT DVD/LD TV/DBS terminals of this unit.
VIDEO AUX TAPE (MD) MON 2CH/6CH
TUNER CD PHONO
2CH/6CH
RX-V592
RX-V692