Yamaha REV100 - Manual (Page 5)

Controls
1
1. Controls
Front Panel
DIGITAL REVERBERATOR
PEAK
L R
INPUT LEVEL
0 10
MIX BALANCE
DRY WET
DELAY
MIN MAX
DECAY
MIN MAX
LEVEL
MIN MAX
POWER
ON OFF
PROGRAM
MIDI
STORE
MIDI INT PGM CHANGE
1
21
41
51
61
71
-20
-40
-50
-60
-70
-99
REVERB
STEREO REV
GATE REV
DELAY
DLY/REV
MOD/REV
1 2 3 7 5 6 4
1 INPUT LEVEL control
This rotary control sets the input level. You should set the
level so that the PEAK (L/R) indicators only flash occasion-
ally.
2 PEAK (L/R) indicators
These LEDs will light when the REV100 is receiving a peak
level signal.
3 MIX BALANCE (DRY/WET) control
This rotary control sets the balance of wet (effect) and dry
(no effect) sounds.
4 LED display (7-segment LED, MIDI indicator, INT indi-
cator)
This 7-segment display indicates the current program in
Program Mode. It shows the value of parameters when the
REV100 is in Edit Mode and it shows MIDI program num-
bers. When you select the MIDI Program Change table, the
MIDI indicator will light, and when you select the internal
programs, the INT indicator will light. Refer to “Setting the
MIDI Program Change Table” on page 7.
5 PROGRAM ( , , MIDI, STORE) keys
These keys allow you to select the different programs, edit
the MIDI Program Change table, and store modified pro-
grams.
6 Edit (DELAY, DECAY, LEVEL) controls
These rotary controls edit the amount of parameters of the
current effect. When the edited value of a parameter is the
same as the currently saved value, the LED to the left of the
control will light. Refer to “Editing a Program” on page 6.
7 POWER switch
Press this switch ON to turn on the power.
Rear Panel
MIDI IN DC 12V IN
R L(MONO)
OUTPUT
R L(MONO)
INPUT
2 1 3 4
1 DC 12V IN inlet
The supplied AC Adapter is plugged into this connector.
2 MIDI IN connector
The REV100 receives MIDI data via this connection.
3 OUTPUT connectors
These 1/4" phone connectors are used to output the pro-
cessed sound from the REV100. If you are using it mono-
phonically, plug a jack into the L-MONO connection only.
4 INPUT connectors
These 1/4" phone connectors are used to plug a sound source
into the REV100. If the source is monophonic, plug the jack
into the L-MONO connection only.