Zenoah BC2300LE - Manual (Page 2)

3 4
■ ENGINE
• Using attached 4 socket screws, secure the
connection firmly with equal force.
B: BC3500WE/BC4500WE
1. Remove the upper cap from the bracket.
2. Loosen the 4 bolts on the clamp and insert
the handles equally.
Retighten the bolts.
3. Put the handle assembly into the bracket
and put the upper cap over it. Tighten the
cap securely.
■ CONNECTING THROTTLE WIRE
1. Remove the air cleaner cover.
2. Connect the end of the throttle wire to the
joint on the top of the carburetor.
■ PROTECTOR
• Wrap the protector around the outer pipe as
shown in the figure, and fasten the magic
fastener.
■ BLADE GUARD
A: BC2310LE/BC2610LE
•
Attach the guard to the bracket and fix it
with 4 screws and nuts.
B: BC3500WE/BC4500WE
•
Attach the guard to the clamp on the outer
pipe just touching the gearcase. Fix it with 2
bolts.
■ INSTALLING CUTTING HEAD
1. While locking the gear shaft by inserting the
attached bar into the upper holder and the
gear box, loosen and remove the hexagon
bolt(left-handed)
2. Fit the spacer attached to the head
assembly between the upper and lower
holders. Then screw in the cutting head to
the gear shaft over the holders. Hand-
tighten it securely.
Setup Fuel
• Keep open flames away from the
area where fuel is handled or stored.
• Mix and store fuel only in an
approved gasoline container.
• Mix a regular grade gasoline (Ieaded or
unleaded, alcohol-free) and a quality-proven
motor oil for air cooled 2-stroke gasoline
engine use.
25 : I Mix Chart
Gasoline liter
1 2 3 4 5
2-cycle oil ml. 40 80 120 160 200
Recommended mixing ratio:
Term Gasoline: Oil
Upto 20 use hours 20 : 1
After 20 use hours 25 : 1
NOTE:
Most engine troubles are caused, directly or
indirectly, by the fuel used on the machine.
Take special care not to mix a motor oil for 4-
stroke engine use.
BC3500WE
BC4500WE
BC3500WE
BC4500WE
■ HANDLE
A: BC2310LE/BC2610LE
•
Put the handle onto the main pipe and fix it
with 4 screws.
5
■ STARTING THE ENGINE
Take care that the cutting head will start
rotating upon the engine starts.
A: BC2310LE/BC2610LE/BC3500WE/BC4500WE
1. Push the primer pump(1) several times until
overflown fuel flows out in the clear tube.
2. Move the choke lever(2) to the closed
position.
3. Set the engine switch(a) to the " I " position.
Set the throttle lever to the start position (1-
2-3).
Use
BC2310LE
BC2610LE
BC3500WE
BC4500WE