Yamaha GX-3 - Manual (Page 21)

E-15
English
Normally, if station signals are strong and there is no
interference, quick automatic-search tuning (Automatic
tuning) is possible. However, if signals of the station you
want to select are weak, you must tune to it manually
(Manual tuning).
Automatic tuning
1
Press the TUNER input selector button.
2
Select the reception band (FM or AM) by pressing the
FM/AM button while watching the display.
3
Press the AUTO/MAN’L button so that “AUTO” appears
on the display.
(In this mode, stations are received in stereo or monaural
automatically.)
4
Press the TUNING button to tune to a higher
frequency, or press the TUNING button to tune to a
lower frequency.
(When tuned to a station, “TUNED” will light up on the
display.)
5
If the station where tuning search stopped is not the
desired one, follow step 4 again.
* If the tuning search does not stop at the desired station,
change to the Manual tuning method as described below.
* STEREO indicator will light up when an FM stereo
broadcast with sufficient signal strength is received.
Manual tuning
1 1
Follow steps 1 and 2 of the Automatic tuning method.
2 2
Press the AUTO/MAN’L button so that “AUTO”
disappears from the display.
(In this mode, stations are received in monaural.)
3 3
Press and hold the TUNING button to tune to a
higher frequency, or press and hold the TUNING
button to tune to a lower frequency.
Release it just before reaching the desired frequency,
and then press it repeatedly until the desired frequency
appears.
(When tuned to a station, “TUNED” will light up on the
display.)
Note
If you tune to an FM station manually, it is received in
monaural automatically to increase the signal quality.
TUNING OPERATION
2 1 4, 3 3 3, 2 2
CD TUNER TAPE POWER
1 2 3
1 2 3
FM/AM
4 5 6
4 5 6
7 8 9
7 8 9
0
0 CD/TUNER
+10
DISPLAY
SLEEP
AUX PLAY/PAUSE
TIME REPEAT STOP
TAPE EDIT PROG RANDOM
MUSIC
LOCATION
USER
VOLUME
TAPE
A
B
REC/
PAUSE
DECK
2
1