Yamaha R CD-S700 - Manual (Page 14)

BASIC OPERATION
10
En
■ Playing back USB devices
Connect your USB device to the USB port on the
front panel. (For details, refer to page 8.)
When USB mode is selected (USB indicator lights up),
first filename is displayed in the front panel display (refer
to page 12), and playback starts automatically in order by
date and time of creation if playable files are in the USB
device.
To disconnect USB devices
Press
to stop playback, and then disconnect the USB
device.
Do not disconnect your USB device while playing back from the
USB device, or when the USB indicator blinks.
Press e.
To resume playback, press e again (or press h).
Press s.
If you press h again, playback starts from the first track.
Press POWER again.
If you turn off the power when disc mode is selected, the
next time you turn the power on, playback starts
automatically of the disc on the tray. If you turn off the
power when USB mode is selected, playback will start
automatically of the USB device connected.
Select a desired track by using the numeric
buttons.
Example: To select track number 12
Press “1”, and then press “2”.
Following information is displayed.
Playback starts in 2 seconds.
This operation is not available for Data Disc and USB.
y
You can also select and playback a desired track during playback.
Press PURE DIRECT.
This unit is set to PURE DIRECT mode.
• The PURE DIRECT indicator lights up.
• The digital output is turned off.
• The front panel display is turned off and only the minimum
required indicators and messages are displayed during
playback.
Connect using the ANALOG OUT terminals when you use
PURE DIRECT mode (refer to page 7).
Note
Pausing playback
Stopping playback
USB
USB Audio CD Data Disc
USB Audio CD Data Disc
Turning off the power
Playing back a desired track
Note
To improve audio quality (PURE
DIRECT mode)
Note
Audio CD
+
The selected track number
USB Audio CD Data Disc