Set up, Important – Zenoah TR2301S User Manual

Page 18

6. Set up

English

Tighten the screws gradually by turns.

■ INSTALLING HANDLE
• Mount the handle to the shaft tube and clamp it at a

location that is comfortable to you. (SE1)

(1) About 11 inches (28cm)

■ INSTALLING CUTTING ATTACHMENT GUARD
• Put the cutting attachment guard on the angle

transmission, attach it with the screws and hardware
provided. (SE2)

■ INSTALLING CUTTING HEAD (SE3)
1. While locking the gear shaft, by inserting the

supplied tool into the upper holder on the gear box,
loosen and remove the hexagon nut(left-handed)

2. Fit the line head assembly to the gear shaft over the

holders. Hand-tighten it securely.

You need not holder (B) and nut when installing the
cutting head.

IMPORTANT

(1)

SE1

SE2

SE3