Zenoah HT2200 - Manual (Page 20)

20
6. Set up
English
SE6
SE7
SE8
■ CHT2200
1. Attach the engine to the clutch housing of the cutter
unit. Casually fix the front 2 points with the screws
(.55" long).
2. After connecting the ground wire, install the rear
handle to the clutch housing with the screw(2" long)
and the nut.
3. Put the screw (1.6" long) through the ground wire
terminal and the rear handle, and in to the engine
mounting base. Securely tighten all of the engine
mounting screws.
4. Attach the front handle onto the gear housing and
fasten with 2 screws (1.2" long) and nuts.
5. Connect the throttle cable with the lever on the rear
handle, and secure the end with the hardware
attached to the handle.
6. Check the cable play and, if necessary, adjust
between .04” and .08” by bending throttle wire
receiver of the bracket with needle nose pliers.