6/7 “options” buttons, 8 display – Zanussi ZWN 1420 G User Manual
Page 7
7
As all spinning phases are suppressed, this washing
cycle is very quiet and it can be useful at night or in
times with a more economical power rate.
On cotton and synthetic programmes the rinses will be
performed with more water.
At the end of the cycle, the door is locked (door locked
light on), the light of the “Start/Pause” button goes out,
the light of “Night Cycle” button remains lit to indicate
that the water must be drained and a flashing zero will
appear on the display.
To complete the cycle, press “Skip Reset” button once,
all the leds are off, the display will show three flashing
dashes, then press “Fabric” button in order to select the
desired programme.
If you wish to drain or spin press the “Skip Reset”
button until the led of the desired function illuminates.
You can change the spin speed by means of “Spin
Speed” button and then depress “Start/Pause” button.
Important!
If you accidentally press the “Skip Reset” button more
than once, the display will show three flashing dashes.
To drain the water, select any washing programme by
means of the “Fabric” button, then press “Skip Reset”
three times in order to select the drain (only the “Drain”
light will remain lit), then press again the “Start/Pause”
button.
6/7 “Options” buttons
Press the first button to select the following options:
• Prewash: for heavily soiled laundry.
Select this option if you wish your laundry to be
prewashed at 50° C before the main wash (not
available for Wool
and Handwash
programmes).
The prewash ends with a short spin at 650 rpm in
programmes for cotton and synthetic fabrics, whereas
in the programme for delicate fabrics the water is only
drained.
• Soak: for heavily soiled laundry.
Select this option if you wish to perform a soak of
about 30 minutes at 30°C before the washing to your
laundry. By pressing the “Delay” button the soak time
can be extended up to a maximum of 10 hours. After
this time the wash cycle will automatically start.
This function is not available for wool and hand-wash
cycles.
The soak ends with a short spin at 650 rpm in
programmes for cotton and synthetic fabrics, whereas
in the programme for delicate fabrics the water is only
drained.
If you have selected the Prewash or Soak option, pour
detergent into the appropriate compartment marked
•
Extra Quick: select this option for laundry that is
only slightly soiled (not available for Wool
and
Handwash programmes).
The washing time will be reduced according to the
type of fabric and the selected temperature.
The Prewash, the Soak and the Extra Quick options
cannot be selected together by means of the same
button.
Press the second button to select the following options:
• Super Rinse: this option can be selected with all
programmes except Wool
and Handwash
programmes. The machine will add 2 rinses to the
cotton programmes and 1 rinse to the synthetic and
delicate programmes. This option is recommended for
people who are allergic to detergents, and in areas
where the water is very soft.
•
40° AA: this option can be selected for cottons and
synthetics lightly or normally soiled with a
temperature of 40°C or higher.
The washing temperature will be reduced and the
washing time will be prolonged in order to achieve an
AA class in energy efficiency and washing
performance. (not available in combination with
Extra Quick option).
The Super Rinse and the 40° AA options cannot be
selected together by means of the relevant button.
8 Display
The following pieces of information are shown on the
display:
• Three flashing dashes, when a programme is
cancelled by means of the “Skip Reset” button.
The three flashing dashes will also appear when you
press the “On/Off” button to switch the machine on, if
the previously selected cycle has been erased.
132983440.qxd 18/10/2005 10:11 Pagina 7