Placing the speakers, Removing the front cover, Specifications – Yamaha NS-325F User Manual
Page 4
E-
4
The front cover is fastened to the enclosure at six points
and can be removed if desired. To remove the cover, hold
on to both sides and slowly pull straight away from the
speaker. To reattach, line up the six holes on the inner
surface of the cover with the six corresponding pegs on the
speaker and push gently.
Note:
When the cover is removed, take care not to touch the
speaker units with your hands or to exert excessive
force with tools.
SPECIFICATIONS
Type ............................. 2-way bass reflex speaker system
Magnetic shielding type
Driver ...................................... 13 cm (5”) cone woofer x 2
3 cm (1”) dome tweeter
Impedance ................................................................... 6 Ω
Frequency Response ................... 40 Hz to 50 kHz (-10dB)
Nominal Input Power ................................................... 50W
Maximum Input Power ............................................. 200 W
Sensitivity .................................................. 88 dB/2.83 V/m
Crossover Frequency ............................................. 2.5 kHz
Dimensions (WxHxD, with the stand)
..................................................... 304 x 984 x 326 mm
(11-15/16” x 38-3/4” x 12-13/16”)
Weight .................................................. 16 kg (35 lbs.5 oz.)
● Specifications subject to change without notice due to
product improvements.
● Care should be taken not to exceed the input power
values noted above.
REMOVING THE FRONT COVER
■ Using as 2ch stereo speakers
Better stereo images will be obtained when the speakers
are slightly angled in towards the listeners.
■ Using as front speakers in a multi channel
system
Position the speakers on both sides of the TV. The
positioning of speakers is important, because it controls the
whole sound quality of a multi channel system. Set up the
speakers on the basis of your listening position by following
the owner’s manual supplied with your amplifier.
Note:
This speaker features a magnetically shielded design,
but there is still a chance that placing it too close to a
TV set might impair picture color or create a buzzing
noise. Should this happen, move the speaker away from
the TV set.
PLACING THE SPEAKERS
Subwoofer
Center
NS-325F
Front
Surround
Surround
back