Zephyr Layers Wall ALA - M90ABX - Manual (Page 17)

6. Attach the 6 pin male molex connector from blower
wire to the 6 pin female molex connector located
inside the blower housing. See Fig.6
7. Install blower and blower plate into blower housing
by following the reverse instructions from step 2
then use the screws provided to complete installa-
tion. (Tot. 14 type B). See Fig.7
8. Connect 9 pin male molex connector from blower wire to 9 pin female molex
connector on the capacitor wire. See Fig.8
WARNING! Place electrical wiring inside the motor housing.
The hood is now ready to be installed on the wall.
Installa
tion - In
ternal Blo
w
e
r
- 17 -