Zanussi ZF 22 W - Manual (Page 9)

9
Defrosting
The freezer compartment will become progressively
covered with frost. This should be removed with the
special plastic scraper provided whenever the
thickness of frost exceeds 6 mm (¼”).
During this operation it is not necessary to switch off
the power supply or to remove the foodstuffs.
However, when the ice becomes very thick on the
inner liner, complete defrosting should be carried out
and it is advisable to perform this operation when the
appliance is empty.
F F
To carry out complete defrosting:
1. It is advisable to disconnect the appliance from the
electrical supply. If the plug is inaccessible turn the
thermostat to „Stop“.
2. Remove any stored food, wrap in several layers of
newspaper and store in a cool place.
Problem
No power to the
appliance
The temperature in the
appliance is too high
The temperature in the
appliance is too low
Excessive frost and ice
has built up
The appliance is noisy.
Possible Cause
No power at the socket.
There is a power cut.
The fuse has blown.
Thermostat control knob is set to „stop“.
The appliance is located in an unsuitable position.
The thermostat control knob is set too low.
The thermostat control is set too high.
The door has been left open.
Something is obstructing the door.
The door gasket is dirty.
The appliance is not level.
Solution
Check there is power at the socket.
Check there is not a power cut by checking the
household lights.
Check the fuse has not blown.
Check the thermostat control knob setting.
Check the ambient temperature is within the
appliances operating limits of 16 °C to 32 °C.
Check that the thermostat control knob is turned to
the correct setting relative to ambient conditions.
Set the thermostat control knob to a lower
position.
Check the door has not been left open.
Check nothing is preventing the door from closing.
Check the door gasket is intact and clean.
Check if the appliance stands stable.
Something Not Working
If the appliance is not working correctly, please carry out the following checks before contacting your local
Service Force Centre.
If after the above checks your appliance still does not
operate correctly, contact your local Service Force
Centre.
Please note that it will be necessary to provide proof
of purchase for any in-guarantee service calls.
In-guarantee customers should ensure that the
above checks have been made, as the
engineer will make a charge if the fault is not a
mechanical or electrical breakdown.
3. Leave the door open.
4. To accelerate the defrosting process place a
bowl of hot (not boiling) water inside the freezer.
5. When defrosting is completed, dry the interior
thoroughly.
6. Turn the thermostat control 'Super' and leave to
run for at least 4 hours.
7. Replace the previously removed food.
8. Return the thermostat control to 'Normal'.
Important
A temperature rise of the frozen food packs
during defrosting may shorten their safe storage
life.
Never use sharp metal tools to scrape off frost
from the evaporator as this could damage the
appliance beyond repair.