Subwoofer jack – Yamaha RX-V430RDS User Manual
Page 13
11
English
INTR
ODUCTION
PREP
ARA
TION
B
ASIC OPERA-
TION
AD
V
ANCED
OPERA
TION
ADDITIONAL
INFORMA
TION
APPENDIX
SPEAKER SETUP
SUB
WOOFER
OUTPUT
4
SPEAKERS
MAIN
REAR
(SURROUND)
CENTER
+
–
+
–
+
–
L
L
R
R
1
5
6
3
2
Subwoofer
system
Center
speaker
Right
Rear speaker
■ SUBWOOFER jack
When using a subwoofer with built-in amplifier, including the YAMAHA Active Servo Processing Subwoofer System,
connect the input jack of the subwoofer system to this jack. Low bass signals distributed from the main, center and/or
rear channels are directed to this jack in accordance with your SPEAKER SET selections. The LFE (low-frequency
effect) signals generated when Dolby Digital or DTS is decoded are also directed to this jack in accordance with your
SPEAKER SET selections.
Notes
• The cut-off frequency of the SUBWOOFER jack is 90 Hz.
• If you do not use a subwoofer, designate the signals to the main left and right speakers by changing the setting of SPEAKER SET
item “1D BASS” on the SET MENU to MAIN.
• Use the control on the subwoofer to adjust its volume level. It is also possible to adjust the volume level by using this unit’s remote
control (see “ADJUSTING THE LEVEL OF THE EFFECT SPEAKERS” on page 47).
Main speaker
Right
Left
Left
1
2
4
3
6
5
The diagram shows the speaker layout in the listening
room.
0103V430_9-19_EN(GB)
1/19/02, 8:03 PM
11