Yamaha 501 - Manual (Page 9)

9
Notes
● After closing the disc tray by pressing the OPEN/CLOSE
button in the stop mode or after selecting any disc by using
the DISC SKIP buttons, the display shows the total number
of tracks and the total recorded time of the selected disc for
a few seconds.
● Additionally, you can close the disc tray by pressing the
PLAY(PLAY/PAUSE) button, a DISC-select button on the
front panel, a numeric button or the RANDOM button, or by
pressing the front edge of the disc tray gently. If the tray is
closed in these ways, play will begin automatically, however,
the display will not show the total number of tracks and the
total recorded time of the first selected disc.
PLAYXCHANGE
During play, you can open the disc tray by pressing the
PLAYXCHANGE button on the front panel without interrupting
disc play. However, in this case, pressing the DISC SKIP
buttons has no effect.
Display information at disc play
➀
Encloses the tray number of the selected disc.
➁
Shows the tray numbers with discs.
➂
Shows the selected track number.
➃
Shows the time displays. (Refer to “Selecting time
displays” on page 11.)
➄ Displays the numbers that correspond to the numbers of
the tracks (as high as number 20) on the selected disc.
After each track is played, its corresponding number
disappears so the number of remaining tracks (and their
numbers) can be seen at a glance.
CDC-901 only
➅ Shows the level of signals output into an amplifier or the
headphone level adjusted by using the OUTPUT LEVEL
buttons.
1 2 3 4 5 6 7 8 9 10 11 12
TOTAL
5DISC
3 4 5 6 7 8 9 10 11 12
REMAIN
5DISC
➀
➄
➂ ➃
➅
➁
To stop play temporarily
To resume play, press the PAUSE button again (or press the
PLAY button).
* The PLAY/PAUSE button on the front panel can also be
used to stop play temporarily or to resume play.
To stop play completely
PAUSE
STOP
or
PLAY/
PAUSE