Yamaha NS-P320 - Manual (Page 14)

E-
10
INPUT1 FROM AMPLIFIER
OUTPUT
TO SPEAKERS
INPUT2 /MONO
AUTO STANDBY
STANDBY-RED ON-GREEN
OFF LOW
HIGH
OFF
POWER
ON
1
VOLUME
0 I0
OFF
POWER
ON
5
6
4
INPUT1
FROM AMPLIFIER
OUTPUT
TO SPEAKERS
INPUT2 /MONO
AUTO
STANDBY
STANDBY-RED
ON-GREEN
OFF
LOW
HIGH
VOLUME
0 I0
2
3
7
VOLTAGE SELECTOR
220V-240V
110V-120V
VOLTAGE
SELECTOR
220V-240V
110V-120V
8
USING THE SUBWOOFER (SW-P201)
1
POWER switch
Set this switch to the ON position to turn on the power
of the subwoofer. When the power of the subwoofer is
on, the power indicator (
2
) below the POWER switch
lights up GREEN. Set this switch to the OFF position
to turn off the power of the subwoofer.
2
Power indicator
Lights up GREEN when the
POWER switch is set to
the ON position and goes off when set to the OFF
position.
* Standby mode
If the POWER switch is set to the ON position and
the AUTO STANDBY switch is set to the HIGH or
LOW position, this indicator lights up RED when no
signal is inputted to the subwoofer.
3
AUTO STANDBY (HIGH/LOW/OFF) switch
By setting this switch to the HIGH or LOW position, the
subwoofer’s automatic power-switching function
operates as described on the next page. If you do not
need this function, set to the OFF position.
* Make sure to change the setting of this switch only
when the POWER switch (
1
) is in the OFF
position.
Standby mode
The subwoofer is still using a small amount of power
in this mode.
4
INPUT2 terminals
Used to input line level signals from the amplifier.
5
INPUT1 (FROM AMPLIFIER) terminals
Used to connect the subwoofer with the speaker
terminals of the amplifier.
6
OUTPUT (TO SPEAKERS) terminals
Can be used for connecting to the main speakers.
Signals from the
INPUT1 terminals (
5
) are sent to
these terminals.
7
VOLUME control
Adjusts the volume level. Turn the control clockwise to
increase the volume, and counterclockwise to
decrease the volume.
8
VOLTAGE SELECTOR switch (General model only)
If the preset setting of the switch is incorrect, set the
switch to the proper voltage range (220V-240V or
110V-120V) of your area.
Consult your dealer if you are unsure of the correct
setting.
WARNING
Be sure to unplug the subwoofer before setting the
VOLTAGE SELECTOR switch correctly.
Rear panel
Ⅵ Controls and their functions