Figure 23 retrieve and backup settings – Z-Com ZMAX-8210-I User Manual
Page 29
Figure 23 Retrieve and Backup Settings
From the“Backup / Restore Settings”
，by clicking“Backup”，a pop-menu will appear,
suggesting you enter:C:\mercury.cfg. After “Confirm”, the mercury.cfg will be saved to your
hard disc.
From the“Backup / Restore Settings”
，by clicking“Backup”，a pop-menu will appear,
suggesting you enter:C:\mercury.cfg. After “Retrieve”, the zmax8210 will retrieve your backup
file.
Backup and Retrieve Files via FTP：
Enter the command ftp 192.168.1.1 admin and password,
After successful commanding, enter“get mercury.cfg”. If the upgrade is successful, enter “get
mercury.cfg” and you’ll see the information as below. A file will be saved to your PC folder
following C:\mercury.cfg；
Enter“put mercury.cfg”
，the file will be loaded to your ZMAX-8210.
Note：
C:\>ftp 192.168.1.1
Connected to 192.168.1.1
220 (vsFTPd 1.1.3)
User (192.168.1.1:(none)): admin
331 Please specify the password.
Password:
230 Using binary mode to transfer files. Login successful. Have fun.
ftp> get mercury.cfg
200 PORT command successful. Consider using PASV.
150 Opening BINARY mode data connection for /mnt/ramd/ mercury.cfg (11411 bytes).
226 File send OK.
ftp: 收到 11411 字节，用时 0.00Seconds 11411000.00Kbytes/sec.
ftp> put zmax8200.cfg
200 PORT command successful. Consider using PASV.
150 Ok to send data.
226 File receive OK.
ftp: 发送 11411 字节，用时 0.02Seconds 713.19Kbytes/sec.ftp> quit
221 Goodbye.
Chapter 5 Management - 23 -