Yamaha RX-460 - Manual (Page 11)

1
Tune to a desired station.
(Refer to the previous page for tuning procedures.)
2
3
Select a desired page (A – E) of preset stations while
watching the display.
4
Select a preset station number while watching the
display before “MEMORY” goes off from the display.
5
* In the same way, program other stations to A2, A3 ... A8.
* You can program more stations on other pages in the same
way by selecting other pages in step 2.
11
Notes
● A new setting can be programmed in place of the former
one.
● For presets, the setting of the reception mode (stereo or
monaural) is stored along with the station frequency.
Memory back-up
The memory back-up circuit prevents the programmed data
from being lost even if the POWER switch is set off or the
power plug is disconnected from the AC outlet or the power is
cut due to temporary power failure. If, however, the power is
cut for more than one week, the memory may be erased. If so,
it can be re-programmed by simply following the PRESET
TUNING steps.
PRESET TUNING
This unit can store station frequencies selected by tuning operation. With this function, you can recall any desired station by only
selecting the preset station number where it is stored. Up to 40 stations (8 stations per page) can be stored.
TO PROGRAM STATIONS TO RECALL A PRESET STATION
3, 1 1 2,5
4, 2 2
MEMORY
MEMORY
PRESET
MEMORY
FM
Flashes on and off
for about 5 seconds.
A/B/C/D/E
PRESET
MEMORY
FM
A/B/C/D/E
PRESET
MEMORY
FM
PRESET STATION
DOWN UP
PRESET STATION
DOWN UP
PRESET
AUTO TUNING
STEREO
0 20 40 60 100 FM MHz
Shows the displayd station
has been programmed to A1.
1 1
Select the page where the preset station is stored.
2 2
Select the preset station number.