Set up – Zenoah BCZ2600SU User Manual

Page 14

14 

6. Set up

SE10

SE11

■ INSTALLING CUTTING HEAD (SE10)
1. While locking the gear shaft, by inserting the

supplied tool into the upper holder on the gear
box, loosen and remove the hexagon nut(left-
handed)

2. Fit the holder attached to the upper holder. Then

screw in the cutting head to the gear shaft over
the holders. Hand-tighten it securely.

■ BALANCE UNIT
1. Put on strap and attach unit to strap.
2. Slide clamp up or down until unit balances with

head just touching on the ground. (SE11)