Zephyr ZVE-E42S - Manual (Page 14)

www.zephyronline.com
12
F
eatures
&
Controls
-
Metal
Filters
Clean
Indicator
Filter Clean Reminder (Standard Metal Filters fitted):
Whether your hood is installed as an Exhaust or Purifying unit, a set of metal filters are fitted by the factory. These Metal
Filters are intended to filter out residue from cooking. They need not be replaced on a regular basis but are required to be
kept clean. The Filter Change Reminder
function in the microprocessor will automatically indicate by a flashing
when the metal filters need to be cleaned after every 30 hrs. of use. Filters can be cleaned by hand with non-abrasive soap
or in a dishwasher. Heavily soiled filters should also be soaked in grease cutting detergent such as Formula '409' or its
equivalent, prior to cleaning.
Filter Clean Reminder:
When flashes on display, the metal
filters installed are required to be cleaned.
This will occur after every 30 hours of use.
Re-setting Function:
Reset the Filter Clean Reminder timer when
filters are cleaned and re-installed (with
hood off). Press and hold for approx.
5 seconds, the display will appear; hold for
approximately 5 seconds until on dis-
play disappears . The Filter Clean
Reminder function is now re-set and a new
30 hours elapse cycle is initiated.
hold 5 secs. display from to < >
display flashes
Clean Filters
To Reset