Yamaha CX-1 - Manual (Page 15)

15
1
Set to the “LEARN” position.
2
Press a key on this unit where a new function will be
learned.
3
Press and hold the key (on the other remote control
transmitter) where the desired new function is.
* When the TRANSMIT/LEARN indicator stops illuminating,
the learning is finished.
4
Repeat step 2 and 3 until all desired functions are
successfully learned.
5
Set to the “USER” position.
Try operating your components.
Notes
● When you operate the desired component with this remote
control transmitter, TRANSMIT/LEARN indicator will flash
steadily.
● The originally preset function of a key is still available in the
USER position if a new function has not been learned to the
key.
● Successful learning to a key results in the erasure of
previously learned functions and their replacement by the
newly learned ones.
● If there is no more room in the memory area for a function to
be learned, the TRANSMIT/LEARN indicator will flash two
times. In this case, even if some keys are not occupied with
functions from other remote control transmitters, no further
learning is possible.
Memory back-up
All of the learned functions will be retained while you replace
the batteries. However, if no batteries are installed for a few
hours, the learned functions will be erased and will have to be
learned again.
Trouble shooting guide
● If learning cannot be made successfully, or if this remote
control transmitter does not function even though the
learning was successful, check the following points:
* Check whether the batteries of the other remote control
transmitter are weak.
Note that even though its batteries may be strong enough
to operate the component it was made for, they may be
too weak to transfer signals to this unit. If so, replace the
batteries of the other remote control transmitter.
* Check whether the distance between the two remote
control transmitters is too long or too short.
● The remote control transmitter’s batteries are too weak if the
TRANSMIT/LEARN indicator does not illuminate or flash, or
if the distance or range within which the remote control
transmitter can be used decreases.
If either occurs, replace the batteries with new ones.
To Learn a New Function
About 5–10 cm (2–4 in.)
Illuminates
This unit
Other remote
control transmitter