Zanussi FLS-879C - Manual (Page 16)

16
If after all these checks, the problem persists, contact
your local Service Force Centre, quoting the model and
serial number. This information can be found on the
rating plate (see picture).
Please note that it will be necessary to provide proof of
purchase for any in-guarantee service calls. In-guarantee
customers should ensure that the above checks have
been made as the engineer will make a charge if the
fault is not a mechanical or electrical breakdown.
Mod. ..........
Prod. No. ...........
Ser. No. .........
Mod.
.......... Ser.
P0042
Symptom
The door will not open
Possible causes
■ The programme is still running.
■ The door lock has not yet released
■ The water level in the drum is too high or the machine is heating.
Spinning starts late or the machine
does not spin ■ The electronic unbalance detection device has cut in because the
laundry is not evenly distributed in the drum. The laundry is
redistributed by reverse rotation of the drum. This may happen several
times before the unbalance disappears and normal spinning can resume
eventually at a lower speed, if the wash load is not perfectly distributed
in the drum. If, after 10 attempts, the laundry is still not evenly
distributed in the drum, the machine will not spin. In this case,
redistribute the load manually and reselect the spin programme.
The machine makes an unusual
noise ■ The machine is fitted with a type of motor which makes an unusual
noise compared with other traditional motors. This new motor ensures
a softer start and more even distribution of the laundry in the drum
when spinning, as well as increased stability of the machine.
No water is visible in the drum ■ Machines based on modern technology operate very economically
using very little water without affecting performance.