Yamaha TSS-10 - Manual (Page 14)

12
PLAYING A SOURCE
Let’s listen to sources played on the audio and video
components connected to this system.
1 Press STANDBY/ON ( ) to turn on the
power.
The STANDBY/ON indicator on the front panel
lights up.
2 Turn on the AV component connected to this
system.
3 Press INPUT repeatedly to select the input
source (DIGITAL 1, DIGITAL 2 or ANALOG).
The indicator for the selected source lights up on the
front panel.
4 Start playback on the source component.
Refer to the operation instructions for the
component.
5 Adjust the volume to the desired level.
The volume level is shown by the VOLUME
indicators on the front panel.
Control range: 0 (minimum) to 7 (maximum)
y
• None of the VOLUME indicators light up when the level is “0
(minimum)”.
Note
• This system can reproduce sampled digital signals (Linear
PCM, Dolby Digital, DTS) of 48 kHz or lower.
■ To adjust the subwoofer level
While listening to a source, press
S.WOOFER – or +.
Pressing + increases and – decreases the level.
y
• While adjusting, the current level is shown by the lighting of
the VOLUME indicators on the front panel. The default level is
also shown by the dim lighting of the corresponding indicator.
Note
• The adjustment cannot be made when listening with
headphones even if + or – is pressed.
■ To adjust the volume balance
between the front and rear
speakers
While listening to a source, press REAR – or
+.
Pressing + increases and – decreases the output level
of the rear speakers.
y
• While adjusting, the current level is shown by the lighting of
the VOLUME indicators on the front panel. The default level is
also shown by the dim lighting of the corresponding indicator.
Note
• The adjustment cannot be made when listening with
headphones even if + or – is pressed.
■ To mute the sound
Press MUTE on the remote control.
To resume the audio output, press MUTE again.
y
• You can also cancel mute by pressing VOLUME +/–, INPUT,
MODE, etc.
• While being muted, the VOLUME indicators flash.
■ When you have finished using
this system
Press STANDBY/ON ( ) to set this system in the
standby mode.
INPUT
MODE
REAR
MUTE TEST
S.WOOFER
VOLUME
SILENT
DIGITAL 1
DIGITAL 2
ANALOG
DTS
INPUT
MODE
VOLUME
DIGITAL
7
6
5
4
3
2
1
+6
+4
+2
0
–2
–4
–6
TRIM
PL MOVIE
PL MUSIC
STANDBY/ON
S.WOOFER
+/–
VOLUME
+/–
MUTE
INPUT
INPUT
VOLUME
REAR +/–
STANDBY/ON
Front panel Remote control
TSS-10Eng(UB)b 02.9.3, 9:15 PM 12