Yamaha CDC-902 - Manual (Page 8)

1
Turn the power on.
2
Open the disc tray and load discs.
3
Close the disc tray
4
Select a desired disc play mode (1DISC or 5DISC)
confirming it on the display.
“1DISC” mode: The unit will play a designated disc only.
“5DISC” mode: The unit will play all discs on the tray in
sequence.
5
Start play from the first track of the disc 1.
* If necessary, select a desired disc by using the DISC SKIP
button or a DISC-select button.
To turn off the power
Press the POWER switch again.
1DISC 5DISC
8
BASIC OPERATION
POWER
OPEN/
CLOSE
OPEN/
CLOSE
MODE
PLAY
DISC SKIP
PLAY
Shows the selected disc
mode.
Disc tray
This manual describes how to operate this unit by using the remote control transmitter.
To operate this unit on the front panel, use the corresponding buttons on the front panel.
2 1
TAPE
SYNCHRO
3 INDEX
PROG CLEAR
8 7 9 0
5 4 6 + I0
DIMMER TIME OPEN/
CLOSE
REPEAT RANDOM MODE DISC SCAN
SEARCH
SKIP OUTPUT LEVEL – +
STOP PAUSE PLAY
DISC SKIP
2, 3
5
4
5
POWER
2 1
SYNCHRO
3 INDEX
PROG CLEAR
8 7 9 0
5 4 6 + I0
DIMMER TIME OPEN/ CLOSE
REPEAT RANDOM MODE DISC SCAN
SEARCH
SKIP
STOP PAUSE PLAY
DISC SKIP
5
2, 3
5
4
2 3 4
DISC
CDC-902 CDC-502
Label side
upward
(On the front panel)
1