Zenoah EHT601D User Manual

Page 26

English

■ CUTTING WORK

• Weather conditions and altitude

may effect carburation.

• Do not allow anyone to stay

close to the hedge-trimmer
while working or while
adjusting the carburetor.

■ HOW TO USE

HANDLE [eHT601D only] (F5)
To reduce fatigue when trimming
hedges, the handle can be swivelled
through 90° to the left or right.

Do not press the throttle during
this operation!

Proceed as follows:
1. Free the handle by pressing the

locking lever.

2. Turn the handle until the locking

lever clicks into place.

3. When the handle is locked in its

new position, you can apply the
throttle again.

(1) Handle
(2) Locking lever

• Use only as much throttle as is

needed to do the job. Excessive
engine speed is unnecessary.

• Avoid cutting thick branches, for

which will damage the blades and
shorten the life of drive systems.

• Tilting the trimmer 5 to 10° to the

cutting object will make the job
easy and bring a good result.

• Always keep your body to the

carburetor side of your trimmer,
never on the muffler side.

• When a new machine is first

operated, in the first few minutes
grease may come out of the gear
case. But, since this is excess
grease, there is no cause for
alarm. Just wipe it off with the
engine stopped for next use.

WARNING

5. OPERATION

F5 [eHT601D]