Zanussi ZWG 7120 P - Manual (Page 7)

• Remove the power supply cable and the draining and
inlet hose from the hose holders ( C ) on the rear of
the appliance.
• Unscrew the three bolts ( A ) and remove the hose
holders ( C ).
• Slide out the relevant plastic spacers ( B ).
• Plug the smaller upper hole and the two large ones
with the corresponding plastic plug caps.
Positioning and levelling
x 4
Level the appliance by raising or lowering the feet.
The appliance MUST be level and stable on a flat hard
floor. If necessary, check the setting with a spirit level.
Any necessary adjustment can be made with a spanner.
7