Yamaha IPA8200 - Manual (Page 12)

IPA8200 Owner’s Manual 57
Specifications
General Specifications
• Half power = 3dB below rated power
• 0dBu = 0.775Vrms
Output Power 4 Ω per channel 200W x 8
8 Ω per channel 100W x 8
1kHz, THD+N=1% 8 Ω / BRIDGE 400W x 4
20Hz-20kHz, THD+N=1%
4 Ω per channel 180W x 8
8 Ω per channel 90W x 8
8 Ω / BRIDGE 360W x 4
1kHz, 20ms Burst
4 Ω per channel 200W x 8
8 Ω per channel 100W x 8
8 Ω / BRIDGE 400W x 4
Maximum Input Level +24dBu
Input Impedance 20k Ω(balanced), 10kΩ(unbalanced)
Input Sensitivity (dBu) Switch Position +4dBu 26dB 32dB
8 Ω, Att. max Input sensitivity +4dBu +5.2dBu –0.8dBu
Voltage Gain Switch Position +4dBu 26dB 32dB
Att. Max Voltage Gain 27.2dB 26dB 32dB
S/N Ratio A-weighted ≥100dB
THD+N 1kHz, half power, 4 Ω ≤0.5%
Frequency Response 1W, 8 Ω 20Hz-20kHz, +0dB, –1.5dB
Channel Separation 1kHz, half power, 8 Ω
Att. max, input 600 Ω shunt
≥60dB
Controls Front Panel POWER switch (rocker)
MUTE switch (push ON/push OFF) x 8
Attenuator (41positon) x 8
Rear Panel MODE switch (STEREO/BRIDGE/PARALLEL) x 4
GAIN switch (+4dBu/26dB/32dB) x 1
HPF switch (OFF/20Hz/55Hz) x 1
Connectors Input Euroblock (balanced)/ch
Output Barrier strip/ch
Power AC inlet x 1
Indicators POWER x 1 (Green), PROTECT x 8 (Red),
CLIP x 8 (Red), SIGNAL x 8 (Green), MUTE x 8 (Red),
PARALLEL x 4 (Orange), BRIDGE x 4 (Orange)
Load Protection POWER switch on/off Output mute
DC-fault Power supply shutdown
Amplifier Protection Thermal Output mute (heatsink temp ≥95˚C)
Over current Power supply shutdown
Power Supply Protection Thermal Power supply shutdown (heatsink temp ≥85˚C)
Limiter Circuit Clip limiting Limiting level ≥100W@8Ω or 200W@4Ω
Cooling High/Low two speed fan x 2
AC Power Requirement U.S./Canada: 120V, 60Hz
Korea: 220V, 60Hz
China: 220V, 50Hz
Other: 220V-240V, 50/60Hz
Power Consumption 400W
Dimensions (W x H x D) 480 x 88 x 406.5mm (18-7/8 x 3-7/16 x 16 inch)
(The depth is measured from the front panel surface to the
rear mounting hardware.)
Weight 10.5kg (23.2 lbs)
Included Accessories AC power cord (2.5m) x 1, Security cover x 1,
Allen wrench x 1, Security cover attachment screw x 2,
3-pin Euroblock connector x 8, Owner’s manual