Zanussi ZF711W - Manual (Page 14)

14
Zanussi 818 15 02--03/3
Technical specification
GB
Model ZF711W
Net volume 286 l
Width 595 mm
Height 1800 mm
Depth 600 mm
Energy consumption 431 kWh/year
Energy class B
Rated power 120 W
Freezing capacity 28 kg/24 hours
Installation
GB
Unpacking
Unpack the cabinet and check that it is in good
condition and free of any transport damage. Notify
the dealer immediately of any damage. Hand the
packaging over for recycling.
Do not allow children to play with the
packaging. The plastic film can cause
suffocation.
Cleaning
Wash the inside of the cabinet using lukewarm water
and bicarbonate of soda (5 ml to 0,5 litre of water).
Do not use soap or detergent as the smell may
linger. Dry thoroughly.
Installing the cabinet
To obtain the best performance from the cabinet,
ensure :
· the cabinet is placed in a dry, cool place and
is not exposed to direct sunlight.
· the cabinet is not placed close to a source of
heat, e.g. a cooker or dishwasher.
· the cabinet is level. The cabinet should not lean
against any wall. If necessary adjust the
feet using the adjustment spanner supplied.
· there is good air circulation around the cabinet
and that the air channels below and behind
the cabinet are not blocked. The ventilation
space above the cabinet must be at least 4 cm.
The ventilation space can either be
a) directly above the cabinet, or
b) behind and above the top cupboard. In this case,
the space behind the cupboard must be at least
50 mm deep.
Cabinet is placed at a location whose ambient
temperature corresponds to the climate
classification*, for which the appliance is designed.
* See on the rating plate on the inside of the
appliance.
The following table shows which ambient
temperature is correct for each climate classification.
50mm
a) b)