beautypg.com

Operation – Yazoo/Kees ZMBI48181 User Manual

Page 20

background image

20

Fuel Valve

FIG - 9

OPERATION

Key Switch

Throttle

Choke

Blade
Engagement

FIG - 8

NOTE: Associated choke on some models.

Hour Meter

The hour meter displays the total operating time

and reminds of service intervals.

Meter will indicate “CHG OIL” for engine oil and

“SVC” for general service at preset intervals.

The hour meter will reset itself at predetermined

times.

Engine “CHG” will come on after the first ten (10)

hours of operation, and will stay on for one (1)

hour of operation before it will reset itself. It will

come on every 99 hours thereafter, and stay on

for five (5) hours of operation before resetting.

Mower “SVC” message will come on every 50

hours to remind to lubricate the unit, check blades

and fasteners, etc. This message will stay on for

two (2) hours of operation before resetting.

Fuel shut off valve is located at the right rear of the
seat. The valve has three positions a right tank, left
tank and center is the off position. FIG - 9.

The pump release valves are located at the right
front corner of the pumps. Used to release the
system so the machine may be moved by hand
when not running. Tilt seat forward to gain access
to the pumps. Use a 5/8” wrench to open valve.
NOTE: Only rotate valve 1/4 turn to release sys-
tem.

Tracking

The tracking knob is located in front of the left con-
trol lever. Rotating this knob allows fine tuning ad-
justments so that the machine tracks straight with
the drive levers in the full forward position.
Rotate the knob clockwise (as viewed from the
operating position) to increase the speed or coun-
terclockwise to decrease the speed on the left
control lever. Example: If control levers are full for-
ward and the unit turns to the right, turn the track-
ing knob counterclockwise to decrease the speed
on the left control lever.

Pump Release

Fuel Shut Off

Hour Meter

Key switch is located on the console. Used to start

the machine. NOTE: Do not run the starter for

more than 5 seconds at a time. If the engine will

not start, wait about 10 seconds before trying

again. FIG - 8.

Key Switch

This manual is related to the following products: