Zenoah BCZ3001S-CA - Manual (Page 20)

20
6. Set up
English
Tighten the screws gradually by turns.
■ INSTALLING HANDLE
• Mount the handle to the shaft tube and clamp it at a
location that is comfortable to you. (SE1)
(1) About 19 inches (48cm)
(2) About 14.5 inches (37cm)
■ HIP PAD
• Fix the tube by the band. (SE2)
(1) Band
■ INSTALLING CUTTING ATTACHMENT GUARD
• Put the cutting attachment guard on the braket,
attach it with the 2 screws. (SE3)
2 kinds of cutting attachment guard are packed in with
BCZ3001SW/BCZ3001SW-CA. Choose the guard
suitable for a line head. If the right guard is not used, it
may lead to a serious accident. (SE3)
(1) Guard for Line Head (Red) : (T3245-24110)
(2) Guard for Blade (Black) : (T3246-24110)
■ INSTALLING LINE HEAD (SE4)
1. While locking the gear shaft, by inserting the
supplied tool into the upper holder on the gear box,
loosen and remove the hexagon nut(left-handed)
2. Fit the line head assembly to the gear shaft over the
holders. Hand-tighten it securely.
You need not holder (B) and nut when installing the
line head.
■ BALANCE UNIT
1. Put on strap and attach unit to strap.
2. Slide clamp up or down until unit balances with head
just touching on the ground. (SE5)
IMPORTANT
IMPORTANT
IMPORTANT
SE1
SE4
(1)
SE2
SE5
(1)
(1)
(2)
SE3
[BCZ3001S]
[BCZ3001S-CA]
[BCZ3001S]
[BCZ3001S-CA]
[BCZ3001SW]
[BCZ3001SW-CA]
[BCZ3001SW]
[BCZ3001SW-CA]