Yamaha DTX XP120SD - Manual (Page 5)

5
 XP100T/100SD/120T
After setting up your rack system (Yamaha RS series, etc.)
or a standard tom stand (Yamaha WS series, etc.), attach
the pad as shown in the illustration. Insert the tom holder
(hexagonal bar) q on your rack or tom stand into the pad,
and firmly tighten the clamp bolt w to secure.
 XP100SD/120SD
Before set up, please prepare a snare stand e (Yamaha
SS652, etc.), and set the XP100SD/120SD onto the stand
as you would an acoustic snare drum.
Use the supplied stereo phone cable to connect the output jack on the XP series pad to the input jack on the DTX Series
drum Trigger Module. Insert the L-shaped connector into the output jack (OUTPUT) on the XP series pad.
Setting Up
CAUTION
• Make sure that the pad is securely attached to the rack or stand. If the bolt is not tightened securely, the pad may
slip or fall down, causing injury. Also, if the rack or stand is placed on an unstable surface, etc., the rack or
stand may fall over, resulting in injury.
Connections
OUTPUT
01_xp120sd_en_c0.fm Page 5 Friday, November 12, 2010 8:10 PM