Zanussi ZEA 85 - Manual (Page 13)

13
30
20 min 60
a
b
FO 1013
3
Dimensions are given in mm.
Building over a kitchen unit with door
Proper arrangements must be taken in designing the
furniture unit, in order to avoid any contact with the
bottom of the hob which can be hot when in
operation. The recommended solution is shown in
diagram 3.
The panel fitted under the hob ("a") should be easily
removable to allow easy access if technical assistance
is needed. The space behind the kitchen unit ("b") can
be used for connections.
Fitting the hob to the worktop
Before fitting the hob into the cut out, a sealing
gasket supplied with the hob must be fitted to the
edge of the cut out. It is essential that no gaps are left
in this seal in order to prevent spillage near the hob
seeping into the cabinet below.
1) Place the sealing gasket all around the edge
of the cut out.
2) Place the hob into the cut out and secure it by
means of the relevant fixing clamps and
screws, as shown in the diagram.
3) Remove the excess seal
The edge of the hob forms a double seal which
prevents the ingress of liquids.
☞
FO 0199
a
Seal