Yamaha DPX-1200 - Manual (Page 17)

13
Projection
6
◆ Turning the power on
Always remove the lens cap before operating the main unit.
Turning the projector power on
1. Insert the supplied power cable
firmly into the AC inlet at the rear
of the main unit, then insert the
plug into an AC outlet.
The STANDBY/ON indicator lights orange.
2. Press the STANDBY/ON button
(the button on the remote
control).
The indicator blinks green and the lamp
lights up in preparation for projection. After
approximately 35 seconds, the indicator
changes from blinking to solid green,
indicating that the unit is ready to project.
Warning
• Do not remove the power cable while the STANDBY/ON indicator is blinking green or
lit steady green. This could damage the lamp or reduce lamp life.
HDMI
G/Y B/PB/CB R/PR/CR
INPUT A
HD/SYNC VD
OUT IN REMOTE TRIGGER OUT
S-VIDEO VIDEO
INPUT B
RGB/YPBPR/YCBCR
RS-232C
D4 VIDEO
STANDBY/ON
SETTING
LAMP COVER TEMP FAN
PATTERN
ESCAPE MENU
INPUT ASPECT
STANDBY/ON
indicator
AC inlet
INPUT
MENU
PATT IRIS
AUTO
SETTING
ASPECT
ZOOM FOCUS V. POS
ESCAPE
STANDBY/ON
SETTING
LAMP COVER TEMP FAN
PATTERN
ESCAPE MENU
INPUT ASPECT
Remote Control Main unit
button STANDBY/ON button
12_DPX-1100_E.p65 11/26/04, 1:47 PM 13