Zenoah BCX2600S - Manual (Page 17)

■ STARTING ENGINE
The cutting head will start rotating upon the
engine starts.
1. Check the oil level in crankcase (See ■ OIL
LEVEL at p.22).
2. Fill the fuel tank with fresh, clean, unleaded
fuel (See p.16) up to 80% of the full capacity.
3. Rest the unit on a flat, firm place. Keep the
cutting head off the ground and clear of
surrounding objects as it will start rotating upon
starting of the engine.
4. Push the primer pump several times until
overflown fuel flows out in the clear tube. (OP1)
5. Move the choke lever downward to the “Start”
position. (OP1)
6. Set the ignition switch to the “start” position.
While pulling the throttle lever, push the set
button, and release the throttle, then the throttle
lever is in the “start” position. (OP2)
7. While holding the unit firmly, pull out the starter
knob briskly. (OP3)
(1) Choke Lever (2) Run (3) Start
(4) Primer Pump
(5) Ignition Switch (6) Start (7) Stop
(8) Throttle Set Button
• Avoid pulling the rope to its end or returning it by
releasing the knob. Such actions can cause
starter failures.
8. When the engine has started or sounds like it
wants to run (normally 2 to 5 pulls), move the
choke lever gradually upword to the “Run”
position. In the case the engine has not started
after opening the choke, pull the starter knob
briskly to start the engine. (OP3)
9. Allow the engine to warm up for a several
minutes before starting operation.
1. When restarting the engine immediately after
stopping it, leave the choke “RUN” position.
NOTE
IMPORTANT
WARNING
8. Operation
OP1
(5)
(8)
(6)
(7)
OP2
OP3
 17 