Yazoo/Kees ZVHO61243 / 968999335 - Manual (Page 18)

18
SETUP AND ADJUSTMENTS
Park Brake Adjustment
When the park brake is on, the spring should
measure 2 3/4” to2 7/8” and have a 1/4”-3/8” gap
between the brake yoke and the washer on the
lower brake rod.
If the spring needs adjusting follow these steps:
1. Apply the park brake.
2. Keep the lower brake rod from turning using a
9/16” wrench on the double nuts.
3. Turn the 3/8F nut at the the end of the spring
the proper direction to achieve the correct
measurement (2 3/4” - 2 7/8”).
4. Repeat on otherside if necessary.
Spring
FIG - 6
If the 1/4” gap is not adjusted follow these step:
1. Place the park brake in the off position.
2. Loosen the 3/8F nut holding the yoke and re-
move the clevis pin.
3. Turn the yoke clockwise to increase the gap.
4. Reinstall the yoke to the brake lever using the
clevis pin and tighten the 3/8F nut to the yoke.
5. With the park brake on check your gap on both
sides.
6. If necessary repeat the above steps.
If each side requires a different gap adjustment.
1. Place the park brake on.
2. Loosen the 3/8F nut next to the trunion.
3. Turn the brake rod clockwise to increase the
gap.
4. Retighten the 3/8F nut to the trunion.
5. Repeat on the otherside if necessary.
3/8F
Nut
Brake Bellcrank
Upper Brake Rod
3/8F
Nut
Yoke
Park Brake Lever
Clevis
Pin
Trunion
3/8F
Nut
3/8F Nut
(Double Nuts)
Lower
Brake Rod
Brake Yoke
1/4”-3/8”
Gap