Yamaha NS-515F - Manual (Page 2)

E-
2
ATTACHING THE STANDS
When placing the speakers, be sure to use the stands to
increase stability.
Note
The provided stands are in two types. Two stands are
for the right side and others are for the left side. Attach
each stand to the proper position on the bottom of the
speaker by following the figure below.
Use the 8 specified holes located on the base of the
speaker.
Pad x 4
Screw
(6mm) x 4
Stand (R x 2, L x 2)
Wood screw
(4mm) x 4
1
2
Procedure:
1 Put the 6mm screw through the large hole on the
stand, and screw it into the speaker at one of the
outside holes on the base of the speaker.
At this time, screw it untightly so that the stand can still
be moved.
2 Put the 4mm wood screw through the other hole on the
stand, and screw it into the other hole on the base of
the speaker.
3 Tighten both of the screws firmly.
4 Attach a pad to the bottom of the end portion of the
stand.
5 Attach the other stands to the other corners of the
base of the speaker in the same way and confirm that
all 4 stands have been firmly attached.
Note
Be carefull not to apply force to the side of the speaker,
otherwise the speaker may fall causing damage to the
speaker or personal injury.
View from the bottom of the speaker
(L)
(R)
(R)
(L)
Front
Back
(L) (R)
NS-515F ENG(02.8.21)a 02.8.21, 8:38 PM 2