XM Satellite Radio SA10113 - Manual (Page 32)

32
Mounting your MyFi on the dash
We’ve included three types of mounts to help you install
your MyFi in your vehicle’s interior.
FLUSH MOUNT: Attach the included
Velcro
® pads or adhesive pad to the
back of your MyFi’s vehicle cradle.
Stick the vehicle cradle onto a flat
surface in your vehicle, preparing
the surface as described below. Do
not install the mount on a leather
surface. Doing so could permanently
damage the surface.
VENT MOUNT: Assemble the vent
mount as shown. Find a horizontal
air vent that is strong enough to
hold the weight of your MyFi and
its cradle. Clip the vent mount into
the vent.
SWIVEL MOUNT: Find a suitable
location; the mount uses a strong
adhesive and you’ll have difficulty
repositioning it after installation.
Do not install this mount on a
leather surface. Doing so could
permanently damage the surface.
Make sure the air temperature is at
least 60°F.
1. Clean the mounting surface with the enclosed surface
preparation kit. Allow to air-dry.
2. Clean the same surface with the alcohol prep pad.
Allow to air-dry.
3. You may warm the adhesive pad using a hair dryer
or the vehicle’s defroster. Place the swivel mount
accurately since it will bond on the first try.
4. For best results, do not touch or apply any pressure
to the vehicle mount for 72 hours.
To remove the swivel mount, first try lifting the adhesive
pad with your fingers or a spoon. You may warm it with
a hair dryer for 2-3 minutes to help soften the adhesive.
Remove any leftover adhesive from the dash surface by
rubbing with your finger, or you can use a mild cleaner
as recommended by your vehicle’s manufacturer.
Warning: MyFi should be placed in your vehicle
where it will not interfere with the function of safety
features, e.g., deployment of airbags. Failure to correctly
place MyFi may result in injury to you or others if the
unit becomes detached during an accident and/or
obstructs the deployment of an airbag.