Zanussi ZT 102 - Manual (Page 4)

INSTALLATION
4
Unpacking
Before starting the machine up, the packing must
be removed as follows.
You are advised to keep all the packaging for re-
use in case the machine is to be transported again.
Using a spanner unscrew and remove the rear right
bolt. Lay the machine gently on its back, making
sure that the hoses are not squashed.
Remove the polystyrene base and take off the
bottom panel by unscrewing the central screw.
Carefully slide out the right polythene bag.
Repeat the operation for the left and central
polythene bags.
Re-fit the bottom panel using the 4 screws supplied
with the door hinges (in the plastic bag) and the
previously removed screw.
Set the machine upright and remove the two
remaining bolts from the back.
Pull out the three plastic spacers from the holes
into which the bolts were fitted.
Plug the open holes with the plugs which you can
find at the back of the appliance.
P0255
P0457 P0015
P0016 P0453
P0256 P0020